Integral Handle And Trigger Assembly - Stanley 07535 MKII Instruction Manual

O R I G I N A L I N S T R U C T I O N

6.8 INTEGRAL HANDLE AND TRIGGER ASSEMBLY

Dismantling Instructions
Refer to drawing 07535-02700 opposite
• Remove the Mandrel and Follower Spring from the tool.
• Disconnect the air supply.
• Remove the Nose Jaw Assembly.
• Insert a 2mm A/F Hex Wrench into the fl ange of the pantograph Handle 197.
• Rotate the handle until the Hex Wrench enters set Screw 191. Loosen the screw one turn.
• Repeat for the other set screw. (The set screws are at 90° to one another.)
• Slide the pantograph handle downwards, and off of the tool barrel.
• Slide the Trigger Actuating Sleeve 198 out of the pantograph Handle 197.
• Hold the pantograph handle in a vice, using a 2.5mm diameter pin gently tap out the Dowel Pin 195. Care must be
taken in retaining the Compressions Spring 196.
• Using a 2mm A/F Hex Wrench loosen set Screw 192 one turn.
• Repeat for the other set screw. (The set screws are at 180° to one another.)
• Remove the pipe from the Male Fitting 194 and slide the Trigger Collar 200 off the tool barrel.
• Using a 2mm A/F Hex Wrench loosen the set Screw 191 from the Trigger Collar 200.
• Remove the Valve Housing 201 together with the Valve 193 and Male Fitting 194 from the Trigger Collar 200.
• Remove the Valve 193 and Male Fitting 194 from the Valve Housing 201.
Assembly Instructions
Assembly is the same procedures in reverse noting the following points.
• Assembly the Valve 193 and Male Fitting 194 to the Valve Housing 201.
• Screw the assembled parts into the Trigger Collar 200 such that the actuating pin of the valve is within 0.25mm of the
Trigger Actuating Sleeve 198 when in the assembled position.
• The Trigger Collar 200 should be fi rm against the plastic housing of the Placing Tool.
• The Retaining Collar 199 should be secured using the two set Screws 191 so that the pantograph Handle 197 is free to
rotate.
Item numbers in bold refer to the illustration and parts list opposite.
E N G L I S H
21