Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
Unpack Range
AWARNING
Excessive Weight Hazard
3.
Push up on kickplate to release plate from shoulder screws.
4.
Lay kickplate to the side to avoid scratching the stainless
steel.
10
Remove shipping materials, tape and film from range. Keep
shipping pallet under range. Remove oven racks, grates and
parts package from inside oven.
2.
Remove screws from kickplate.
A. Kickplate
B. Remove these screws.
5.
For 48" (121.9 cm) models only, rotate center support
counterclockwise off the pallet until it stops.
NOTE: This support is used only for shipping and is not
needed for installation.
6.
Lay a piece of cardboard from side packing on the floor
behind range. Using 2 or more people, firmly grasp each side
of range. Lift range up about 3" (8.0 cm) and move it back
until range is off shipping pallet. Set range on cardboard to
avoid damaging floor.
nstall Optional Backguard
All ranges may require a backguard. See "Cabinet Dimensions" in
the "Location Requirements" section. See the "Tools and Parts"
section for information on ordering.
Remove island trim and attach backguard using 6 screws, insert
3 from the front and 3 from the back (9" [22.9 cm] backguard
shown).
Advertisement
Table of Contents
