Table of Contents
Advertisement
SECTION 2 INSTALLATION
2.1 UNPACKING
Remove the packing list and verify that all equipment has been received. If there are
any questions about the shipment, please call the OMEGA Customer Service
Department at 1 -800-622-2378.
Upon receipt of shipment, inspect the container and equipment for any signs of damage.
Take particular note of any evidence of rough handling in transit. Immediately report any
damage to the shipping agent.
NOTE
The carrier will not honor any claims unless all shipping material is
saved for their examination. After examining and removing
contents, save packing material and carton in the event reshipment
is necessary.
All units are supplied with carrying case, connector leads, type K thermocouple
extension cable with male connector, calibration certificate, TAS-U-5 connector, and AC
power adapter.
2.2 REMOVING THE CARRYING CASE
In laboratories and maintenance shops, the CL521 is easiest to use without its carrying
case. In order to remove the carrying case, be sure the AC adaptor is not connected,
then open both carrying case flaps and the strap around the instrument. Lift the rear of
the instrument about an inch, lift the front of the instrument, and pull it out of the case.
The unit's carrying handle may then be turned downwards in front to act as a stand for
easier viewing. The unit is installed into its case in the reverse order.
In the field, the carrying case is most convenient. When carried around the neck, the
unit can easily be used merely by opening the flap in front of the panel and turning it over
to the back of the case.
Figure 2-1. Removing the Carrying Case
2
Advertisement
Table of Contents
