Table of Contents
Advertisement
Mechanical Installation
The SP-001 / SP-002 requires a Smart Interface (IF-001-0) or Wireless Transmitter to connect to your computer. Locate the
position of the keyway as a guide on the SP-001 / SP-002 prior to making the connection. See Figure 6.
The sensor can be mounted on brackets, clamps or cutouts of your own design or you can use the fixed and adjustable
Omega mounting bracket accessory: SP-001-MB.
Note:
SP-001-MB accessory is sold separately.
Software Setup
Ensure Omega Sync is running before continuing. The SP-001 / SP-002 Infrared Smart Sensor is configured exclusively
through the Omega Sync software. To connect your SP-001 / SP-002 to Omega Sync, follow these instructions.
Note:
Omega Sync is available to download on the Omega website.
Connecting to Omega Sync – Automatic Detect
Once the SP-001 / SP-002 and Smart Interface are connected to your computer, Omega Sync will automatically detect it and
begin displaying temperature readings.
Note:
If you have successfully connected your SP-001 / SP-002 to Omega Sync, skip ahead to section Setting
Emissivity. If you were not successful in connecting your device, proceed to Connecting to Omega Sync – Manual.
Connecting to Omega Sync – Manual
If Omega Sync does not automatically detect your device, follow these instructions to manually connect your device.
Step 1:
Click on the
Step 2:
Proceed through the Add Device Wizard and click End Device / Probe. See Figure 8.
icon located on the top left of the Omega Sync interface.
Figure 6
Figure 7
Figure 8
8 |
P a g e
Advertisement
Table of Contents
