Table of Contents
Advertisement
• B
Step
Step
The following indicators should appear on all attached display
stations that are powered on.
• The cursor
II
should appear in the upper left-hand corner of
the screen.
• The System Available indicator
E1
should appear at the bottom
of the screen.
• m
Note: The cursor style and the System Available indicator may be
different on your display station screen.
If these indications do not appear on at least one display station,
refer to the problem determination procedures in the /BM 5394
Remote Control Unit Operator's Guide and Problem Determination
Procedures.
4
Set the control unit Test switch to On.
5
At the display station closest to the control unit, press the Test
Request key sequence. Refer to the IBM 5394 Remote Control Unit
Operator's Guide and Problem Determination Procedures for the
correct key sequence for your keyboard.
Press the D key.
Note: You can use any display station except an IBM PC using
AS/400 PC Support or IBM Personal System/2 using AS/400 PC
Support. However, you can reach the switches more easily if you
use the display station nearest the control unit.
Chapter 3. Setup
and
Operation of an
IBM
5394 with a V.35 Communications Interface
11
Advertisement
Table of Contents
