IBM 5394 Manual page 16

Step 11
Make sure the system diskette is not write-protected. Insert the
diskette.
Set the control unit power switch to on (I).
Step 12
All the control unit indicators come on for about 1 second. Then all
indicators except the Power indicator go off. Within 2 minutes, the
Ready and Work Station Active indicators come on.
Check
Disk
ICJI
Test
~On
Off
Ready Com
Work Power
Line Station
Sync Active
1-1
ICJI 1-1 1-1
~~
Do the indicators come on?
Yes IBM 5394 setup is complete.
For normal operation, the diskette (not write-protected)
must be in the diskette drive.
No Do the following:
Make sure all the cable connectors are secure.
If the indicators are still not on, refer to IBM 5394 Remote
Control Unit Operator's Guide and Problem Determi-
nation Procedures.
If a 091010 system reference code (SRC) appears on the
screen, contact your customer service representative and
report that the RPQ is not operating correctly.
If any other SRCs appear on the screen, refer to IBM 5394
Remote Control Unit Operator's Guide and Problem
Determination Procedures.
Chapter 3. Setup and Operation of an IBM 5394 with a V.35 Communications Interface
9