Bosch 4410L Operating/Safety Instructions Manual page 33

Crown Molding Angled to Table and Fence
The preferred method for cutting crown molding with
this saw is with the molding laying flat on the table.
• The advantage to cutting moldings angled against
fence is that no bevel setting is required. Only the
miter angle is adjusted.
• The maximum crown molding width that can be cut
and angled to table and fence is 4-5/8".
• When cutting crown molding in this fashion it is
recommended to purchase and use the optional
MS1228 Crown Molding Support Stop Accessory.
Follow these instructions for cutting
crown molding angled to table and fence.
1. Position the molding so the bottom (decorative
part, which is installed against the wall) is against
the fence.
2. For 90 ° corner, set the miter angle using Chart
below. -iqghten the miter lock knob.
3. Support crown molding against the fence (see
"Body and Hand Position" on page 21 ).
4. Follow the procedures for chop or slide cut (see
page 26).
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
NOTE: ALWAYS TAKE A TEST CUT USING
SCRAP TO CONFIRM CORRECT ANGLES.
Crown Molding
Angled Against
Fence
\
__ 45 ° Miter J
Figure: Crown Molding Angled to
Table and Fence
Miter and Bevel Settings for Standard Crown Molding Cuts
(When Workpiece Angled Against Fence)
Assumptions: Molding is milled consistently.
• Corner is 90 degrees.
• For other corner angles, divide actual measurement
by 2.
For any Crown Molding
Miter Bevel
(Table) (Tilt)
Setting Setting
Inside Corner
Left end (A)
Use the right end of the cut
Right end (B)
Use the left end of the cut
Outside Corner
Left end (C)
Use the right end of the cut
Right end (D)
Use the left end of the cut
(45) Right
(45) Left
(45) Left
(45) Right
0 Left
0 Right
0 Right
0 Left
33.