Juniper SRX300 Quick Start Manual page 7

Hide thumbs Also See for SRX300:

Table of Contents

After you configure the SRX300, you can log in on a local LAN port, or remotely over the WAN interface, to manage and

configure the SRX using the CLI or J-Web.

We recommend that you use the ge-0/0/0 interface for WAN connectivity on the SRX300. By default, this interface is

set to receive its Internet access configuration from the service provider.

NOTE:

This examples assumes you are using DHCP to configure the WAN interface. If the WAN provider does

not support DHCP, you'll need to manually configure the WAN interface and related static routing. See

Initial

Configuration.

Have this information handy before you begin the initial configuration:

Root password

Hostname

Connect to the Serial Console Port

1. Plug one end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter for your SRX300.

NOTE:

We no longer include a DB-9 to RJ-45 cable or a DB-9 to RJ-45 adapter with a CAT5E copper cable

as part of the device package. If you require a console cable, you can order it separately with the part number

JNP-CBL-RJ45-DB9 (DB-9 to RJ-45 adapter with a CAT5E copper cable).

2. Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management device.

3. Connect the other end of the Ethernet cable to the serial console port on the SRX300.

S R X 3 0 0

Junos

Table of Contents