Kenwood TM-241A Instruction Manual page 55

DTMF unit DTU-2
. 1. Remove the 2 screws securing the Top cover.
2. Carefully remove the top cover. (Fig.1 )
3. Remove the backing from the small cushion
provided with the DTU-2 and attach it to the back of
the DTU-2 as shown in Fig. 2
4. Plug the three connectors into the sockets in the
units.
5. Attach the cable from DTU-2 as shown in Fig. 2 and 3.
6. Replace the cover and tighten the screws to complete
the installation.
Olnstalling TSU-6 and DTU-2
Attach these units on the top of VCO shield (Fig.3).
Not use this
connector
Fig. 3
55