Kenwood TM-241A Instruction Manual page 42

5-10-1 Paging Code Memories
There are five(5) paging code memories.
Use
Store your individual ID code in memory.
Automatically stores the calling station's
code during reception. Can temporarily |
set code for the station.
PO
Stores group codes and local station |
codes in memory. )
5-10-2 Setting the Paging Codes
1. Press the DR/DT key to enter the paging mode. The P
indicator will light.
2. Press the F key, then press the DR/DT key while the F
indicator is on. The code setting mode will be
entered and the memory channel indicator will flash.
3. Set the desired memory (О to 3 or A) with the tuning
control (or key 0 to 3 or A on the microphone [op-
tion] with DTMF).
42
. Press the DR/DT key. The first digit will flash.
(Not necessary this operation if you use DTMF
microphone)
. Set the desired number with the tuning control and
press the DR/DT key (or key O to 9 on the microphone
with DTMF). The first digit will be set, and the
second digit will flash.
.Set the second and third digits with the tuning
control, and press the DR/DT key.
. If, after 10 seconds, no key has been pressed, or a key
other than DR/DT or MR/M is pressed, the code will
be set.