Kenwood TM-241A Instruction Manual page 20

9-3 TRANSMITTER OPERATION
Caution
1. Ensure that an antenna with а low standing wave |
ratio (SWR) is attached to the antenna connector |
before attempting to transmit. Failure to provide |
proper termination
may
result in damage
to the
final amplifier section.
2. Always check to ensure the frequency is clear
before transmitting.
. Check the frequency to see if it is occupied before
you transmit.
. Press the PTT switch. The ON AIR indicator will light,
and the RF meter will deflect to the right.
If you have selected the LOW power position, the low
indicator will appear in the display and the RF meter
will only deflect slightly. When НІ power has been
selected the RF meter will deflect full scale.
. Speak into the microphone. The recommended
distance to the microphone is 5 cm (2 inches).
Е аел елаша. мои.
5-3-1 Transmit Basics
2. Press the HOM ad to select the desired transmit
output.
i550
| ee ਦੇ ਤਦ ਤੂ ਦੇ =<==== ਕਉ << Oe LO
ਆ
20
: Note
| The use of LOW power is recommended
кə
5-3-2 Time-out Timer (TOT)
Тһе ТОТ can limit the continuous transmission time to
30 minutes.
1. Press the F key for longer than 1 second, then press
the LOW/DIM key. The T indicator will light. To cancel
the setting, tepgan the PAO
Press the key for longer than
1 second.
2. When the time-out timer reaches the transmission
time limit, a beep will sound and the transceiver will
return to the receive mode. To transmit again,
release the PTT switch and press it again.