Kenwood TM-241A Instruction Manual page 15

5-1-4 Microphone
= A o
| ]
ж $ (8) m
а ФО
Ф (5)
2)
0 \ ^f i |
5. ~+ - Фа
Ё - = 52900
i 5985
"ыл; KENSOOD dm
Oo Xem,
оф ж B
ie] б?
sett
European version version
QAUP/DOWN switches
These switches can be used to increase or decrease
the VFO frequency, the Memory channel number,
and the Tone frequency, etc..
(3) PTT (Push to Talk) switch
The transceiver will transmit whenever this switch is
depressed. Scan operations may be canceled by press-
ing this switch without transmitting.
(4) CALL key (except European version)
This key functions just like the CALL key on the front
of the radio. we
1750 key (European version)
The transceiver will transmit with 1750 Hz repeater
access tone whenever this switch is depressed.
(5) VFO key
This key functions just like the VFO key on the front
of the radio.
(6) MR key
This key functions just like the MR key on the front of
the radio.
(7) PF (Programmable Function) key
This key can be programmed to perform any of the
following functions:
key.
To program the key use the following procedure:
1. Turn the POWER switch on the transceiver OFF.
2. Press and hold the key on the front panel of the
set that corresponds with the function you wish to
program the microphone key to perform.
4. Release the front panel key.
One additional function can be programmed that is
ING mode.
MONITOR programming
then release the F key.
(8) 16-Tone DTMF keypad (U.S.A. and CANADA version
only)
er.
($9 LOCK key
15