Kenwood TM-241A Instruction Manual page 24

@ CALL Channel
1. Press the VFO/MP V key to
select the VFO mode.
2. Select the desired operat-
ing frequency ,offset,tone
frequency,etc.( For exam-
ple 145.500MHz ).
3. Press the F key. The F indi-
cator and the memory
channel indicator X will
light.( For example CH 8)
4. Press the CALL key within
10 seconds of pressing the
F key. The F indicator and
the Memory Channel num-
ber will turn OFF,to con-
firm data entry.
5-4-7 Memory Channel Recall
1. Press the MR/M key.
2. Rotate the tuning control or press the microphone
UP/DWN switches to select the desired memory
channel.
24
5-4-8 Memory Shift
This feature copies Memory Channel or Call channel
data to the VFO.
This will allow you to recall and alter these frequencies
without changing the actual contents of the memory or
CALL channel.
1. Press the MR/M key or CALL key to select the MR
mode or CALL channel mode.
2. Press the F key. The F indicator will light.
3. Press the VFO/MPV key within 10 seconds of pressing
the F key. The F indicator and the Memory or CALL
Channel indicator will turn OFF to signal the data
has been successfully transferred to the VFO.
If an Odd Split Memory channel is selected, only the
receive data will be copied.