Troubleshooting - HoMedics BPW-930BT Manual

TROUBLESHOOTING
If any abnormality arises during use, please check the following points:
SYMPTOMS POSSIBLE CAUSES CORRECTION
Unit does not turn on when Batteries have run down. Replace them with two new "AAA"
the START/ STOP button is
alkaline batteries.
pushed.
Battery polarities have been
Re-insert the batteries in the correct
positioned incorrectly. positions.
EE measurement error symbol Cuff has been placed Wrap the cuff properli so that it is
shown on display or the blood incorrectly. positioned correctly. easure again.
pressure value is displa~ed
Did you talk or move during Keep wrist steady during
excessively low (or high .
measurement?
measurement. Measure again.
Shaking of the wrist with the
cuff on.
E1 error symbol shown on
display.
Air circuit abnormality. Check cuff placement. Measure
again.
E2 error symbol shown on Inflation pressure exceeding Switch the unit OFF, then measure
display. 300 mmHg. again.
E3 error symbol shown on
display.
Can't determine blood pressure
measurement data.
Rewrap the cuff properly, keep
steady, and measure again.