Kenwood TM-201A Instruction Manual page 6

@ HI/LOW switch
<=
— LOW
@ Display
®
Frequency display
Scan indicator
VFO B indicator
MR indicator
ALERT indicator
ON AIR indicator
BUSY indicator
S & RF meter
Note: Illustrated is a version other than that of Europe/England.
@ 9@
| POWER/VOL SQUELCH
HI setting: This setting allows the transmitter to transmit power output up to 25
watts.
LOW setting: This setting allows the transmitter to transmit power output
approx. 5 watts.
M0
® © &e h
During VFO A or B, frequency, for example, 145.02 is displayed in four digits
as '5.020 "', 5.020
During MR (M1 — M5) operation, frequency, for example, 145.24 is
displayed in 4 digits as ''5.240"". 5.249
During COM* operation, frequency is displayed in four digits. At this time, zero
at the last digit is half size.
* European and British versions excluded.
During scan operation, this dot flashes.
n operation other than scan, this dot lights to show MHz.
Lights when VFO B is in operation.
Lights during memory recall operation (M1 — M5, MS).
Lights during alert operation.
Lights when transmitting.
Lights during reception with squelch opened.
This can be used to see if the channel is busy or not.
ndicates the incoming signal strength by LEDs during reception.
During transmission, LEDs light to show the RF output level strength.
With the HI/LOW switch HI, al! LEDs light.
With the HI/LOW switch LOW, two to four LEDs light.