Kenwood TM-201A Instruction Manual page 10

Mi COMMUNICATIONS SPEAKER INSTALLATION
Note: To keep driving safe, do not install the speaker to the ceiling.
Speaker
Cushion (A)
Example 2-3
Securing bracket
Example 2-2
Example 2-1 Pa (to $4)
a A '7
Mounting Mounting
surface surface
oo ° © ©} Tapping screw foume) fo) 5 | Round head
x8 screw
is ($4 10)
Bracket
Tapping screw
(4x 8)
Faeroe 226 ae
1
2)
3)
® Installation procedure
4)
5)
Fig. a Boss securing
Flathead Boss Flat
screw washer
Be sure to use flat washers. Otherwise, in-
stallation to the mounting bracket is not done
well. However, when stack installation with
the TM-401 is attempted, do not use these
washers since the stack plates are used.
we
Cushion (A)
Cushion (A)
Example 2-8
Speaker B. ) Tl
w |
Cushion (A)
Secure the bosses on each side with 4 flat head screws. (Fig. a)
Affix the cushion (c) on each side of the mounting bracket. (Fig. b)
Secure the mounting bracket to a car chassis as shown in Fig. c.
When installing the bracket, be sure the front part of the bracket faces you.
Insert the transceiver as shown in Fig. d so the bosses on the transceiver
slide into the grooves of the mounting bracket.
To stack with the TM-401A (70 cm), first secure the supplied stack plate
to the TM-201A with bosses then stack the TM-401A, second insert the
stacked transceivers as shown in Fig. d so the bosses on the upper
transceiver slide into the grooves of the mounting bracket.
Fig. b Cushion attachment
Affix the cushion (B).
Affix the cushion (C)
on each side.