Kenwood TM-201A Instruction Manual page 15

@ MEMORY INPUT IN (REPEATER COM CHANNEL AND*) MEMORY CHANNEL
(1) In memory channels 1 — 3
(Simplex channels)
(2) In memory channels 4, 5
and COM* (split channel)
@ SCAN OPERATION
Procedure
Operation
Freq. setting
Set frequency to be stored using the tuning control or
mic UP or DWN switch.
Memory standby Depress the M/M4 key. The beep will sound eight times.
Depress M1, M2 or M3 key while the beep is sounding.
Memory input The 1.5 second beep sounds to verify the memory input.
Procedure Operation
Receive freq. Set receive frequency to be stored using the tuning con-
setting trol or mic UP or DWN switch.
Memory standby | Depress the M/M4 key. The beep will sound eight times.
Memory input
Depress M4, M5 or COM* key while the beep sound is
sounding.
The 1.5 second beep sounds when the memory is input.
Then the beep sounds 4 times repeatedly to require a
transmit frequency input.
Transmit freq.
setting
Set transmit frequency to be stored using the tuning con-
trol, mic UP or DWN switch, or MHz key.
Memory input
(transmit)
Depress the same key used in step 3.
The 1.5 second beep sounds when the memory is input.
* European and British versions excluded.
(1) Memory scan (Memory
channels 1 — 5 are scanned.)
Procedure
Operation Indication
Scan start
Depressing the MS key initiates scan from
memory channel 1 to 5 as shown.
Empty channel is skipped.
rm Mates oneeers hia .
Flashes
Scan will stop at busy station.
Quick scan
Depressing
the MS key recalls the next
memory channel.
Depressing the A/B key or the mic PTT switch
stops the scan.
The displayed memory channel is restored to
memory recall mode.
4 | Scan release
Lights
15