Kenwood TM-201A Instruction Manual page 11

Paks eR
Fig. c Mounting bracket installation
Mounting |
surface Flange nut Mounting surface
Ae
A
Hex. head bolt
¢ Antenna Installation
Roof-top system
Roof side system
CED GSD
Front fender Trunk lid system
Installation for mobile operation.
Be sure to use a duplex mobile antenna.
Coax. cable routing
* Ignition noise
\ Flat washer
\\'Spring washer
\.\ Flat washer
Tapping screw
Mounting bracket
Mounting surface
tm 4 oe
To install the bracket on a
bent mounting surface, bend
these parts as shown. Rear part of the
bracket.
Fig. d Transceiver installation
Transceiver installation
Ensure the front/rear of the bracket
when mounting.
Bosses
aoe
Rear Front
TM-201A
Flat screw TM-401A
Stacking plate
Various types of antennas for VHF mobile operation are available.
Note:
Antenna installation
'Antenna bracket
Remove the paint to in-
sure grounding to the
car body.
Pass through the rear
window.
a
Pass through the door fit-
ting. The cable can be in-
serted easily if the door
cushion is soft. Note that
rain water may enter
along the cable.
Lift the trim plate and
install the cable.
resistors).
11