Trane 4TVH0086FE000AA Service Manual page 130

3.2 Normal Operating Parameters of Refrigerant System
Under the following conditions, the operating parameters given in Tables 5-5.4 and 5-5.5 should be observed:
 The outdoor unit can detect all the indoor units.
 The number of indoor units displayed on DSP2 is steady and is equal to the actual number of indoor units installed.
 All stop valves are open and all indoor unit EXVs are connected to their unit's PCB.
 If the combination ratio is 100% or less, all the indoor units are currently running and if the combination ratio is more
than 100%, indoor units with total capacity equal to the capacity of the outdoor unit are currently running.
 If the outdoor ambient temperature is high, the system is being run in cooling mode with the following settings:
temperature 17°C; fan speed high.
 If the outdoor ambient temperature is low, the system is being run in heating mode with the following settings:
temperature 30°C; fan speed high.
 The system has been running normally for more than 30 minutes.
Table 6-3.4: Outdoor unit cooling mode operating parameters
Outdoor ambient temperature
Average discharge temperature
Average discharge superheat
Discharge pressure
Suction pressure
DC inverter compressor current
Table 6-3.5: Outdoor unit heating mode operating parameters
Outdoor ambient temperature
Average discharge temperature
Average discharge superheat
Discharge pressure
Suction pressure
DC inverter compressor current
°C < 10
°C 60-76
°C 17-30
MPa 2.3-2.8
MPa
0.6-0.7
A 9-20
°C < -10 -10 to 0
°C
56-74 57-76
°C 17-35 17-35
MP
1.7-2.4 1.8-2.5
a
MP
1.4-1.6 1.5-1.7
a
A 11-25 13-27
10 to 26 26 to 31
62-78 65-82
17-33 17-34
2.3-2.8 2.4-3.6
0.7-0.9 0.8-1.0
11-22 12-25
0 to 5
58-78
17-35
1.9-3.0
1.6-2.2
12-28
129
31 to 41 > 41
67-92 69-92
17-36 10-32
2.6-3.8 3.1-4.2
1.0-1.2 1.2-1.4
15-29 20-26
5 to 10 10 to 17
61-82 63-82
17-33 14-33
2.2-3.2 2.3-3.2
1.8-2.6 1.8-2.6
11-28 11-25
> 17
63-82
14-33
2.3-3.2
2.0-2.4
15-20