Advertisement
Available languages
Available languages
Notes on Installation
— .
|
To prevent internal heat buildup in the unit
Place the unit in a location with adequate air circulation.
Do not install the unit:
- near heat sources such as radiators or air ducts.
- in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
Installing Batteries
Do not place anything on top of the cabinet.
The top ventilation holes must be unobstructed for the
proper operation of the unit and to prolong the life of its
components.
Do not throw away the carton and packing material!
It will be an ideal container when transporting the system for
repair work, etc.
Before operating remote commander, install the batteries as shown.
2 Two size AA (R6) batteries
Note on STR-GX90ES
If you remove the wood side panels, secure the sides
of the unit with the supplied short screws (M4 x8).
For safety, turn off the unit before doing this.
To avoid damage caused by battery leakage and corrosion
When the commander will not be used for along time, remove the
batteries.
Battery life
Normal operation can be expected about half a year using Sony
SUM-3 (NS), and a year using Sony AM-3 (NW) alkaline batteries.
When the batteries are run down, the remote commander will not
operate the unit. In this case, replace batteries with new ones.
Changing the AM tuning interval
The AM tuning interval is preset to 10 kHz. To use the receiver where the
frequency allocation system is based on a 9 kHz interval, make the
following adjustments.
1
Turn on the power and tune in any AM station.
2
Turn off the power.
3
Press POWER while pressing the "+° TUNING button.
To reset the AM tuning interval, repeat the above steps.
Caution
When the interval is changed, all preset stations which you have
memorized will be erased. After changing the interval, be sure to preset
the stations again.
Advertisement
