Advertisement
Available languages
Available languages
If the LEARN indicator flashes or does not go out in step
2-@, ©-
The memory capacity has become full. This occurs when
other signals stronger than the remote-control signals have
been stored because the signals were programmed in a
noisy environment or the remote commanders were placed
too far apart from each other.
— Clear all the signals following the procedure on the right
and program again from the beginning under the proper
conditions.
Notes on programming
« Remote-control signals of equipment of manufacturers
other than Sony can be programmed only when they are
compatible with the infrared wireless remote control
system. Since the programmable commander can "learn"
only the signals output from anothér remote commander, it
cannot control equipment that does not use a remote
commander. Also, note that there are some special
remote-control signals that cannot be programmed.
e Do not attempt to use the programinable commander with
an air conditioner or other household appliances.
To program a new signal onto a previously
programmed button
Follow the programming procedure.
The previously programmed signal is cleared and
replaced by the new signal.
To clear all programmed signals
1 Set the mode selector to LEARN.
2 Press and hold any button of the programmable area
untit the LEARN indicator lights up.
3 Press PROGRAM CLEAR until the LEARN indicator
flashes and goes off.
It is not possible to clear the programmed content of just
one button.
To program a signal onto the @ REC button in the
TAPE or VTR section
It is not possible to operate any equipment with only the
@ REC button. To program a signal under the @ REC
button, press and hold the following buttons at the same
time in step 2-@.
Fey
ah ice} iiakem axons
li odeatcvane
By switching the mode selector as shown below, a single button alternately controls Sony equipment and other manufacturer
equipment.
To control Sony equipment
USER STD
cor}
STD
LEARN
aga
When Sony equipment cannot be remote-controlled
Program the signal in the same way as for equipment from
other manufacturers. In this case, even with Sony
equipment, set the mode selector to USER STD.
Notes on Battery
If the LEARN indicator does not light when a button is
pressed, the batteries are almost exhausted.
When the batteries are exhausted, the remote commander
can no longer operate the unit or programming becomes
impossible.
If this happens, replace both batteries with new ones. We
recommend the use of alkaline batteries for prolonged use.
To control equipment with programmed signals
USER STD
so TL
STD
LEARN
If no signal has been programmed
The programmable commander can control Sony equipment
even when the mode selector is set to USER STD.
If the equipment works incorrectly
Press RESET.
The programmed contents of the buttons are not cleared by
pressing RESET.
25
Advertisement
