Advertisement
Available languages
Available languages
Bicolele)(ss-Javelejtiale me lUl(e(=
Before proceeding through the check list below, examine the connections and the procedures outlined the manual.
Should any problem persist after you have checked the following items, consult your nearest Sony dealer.
Sound is not heard.
The ADAPTOR jacks are not in use
Press the ADAPTOR button to set to
and the ADAPTOR button is ON.
OFF.
The equipment connected to the
Set the ADAPTOR switch to OFF or
ADAPTOR jacks is not turned ON.
turn on the connected equipment.
The speaker or program source
Connect the equipment correctly.
equipment is not connected correctly.
| (See pages 8 - 10.)
The correct speakers are not selected | Set the SPEAKERS selector
with SPEAKERS selector.
correctly.
The correct FUNCTION selector is
Press the correct FUNCTION
not pressed.
selector.
The volume is set to minimum.
Increase the volume.
The BALANCE control is not set
Adjust the BALANCE control.
appropriately.
The speaker or program source is not | Connect the equipment correctly.
connected correctly.
(See pages 8 - 10.)
A short-circuit problem activates the
Turn off the receiver, eliminate the
protective circuit.
short-circuit problem and turn on the
power again. If there is no
short-circuit, consult your nearest
Sony dealer,
Set the SPEAKER IMPEDANCE
SELECTOR correctly.
One channel does not transmit audio,
or the volume from the left and right
speakers is unbalanced.
There is an abrupt loss of sound from
one or both of the speakers, and the
[P indicator flickers in the display
window.
The SPEAKER IMPEDANCE
SELECTOR on the rear is not set
correctly.
Lack of bass sound or obscure
The speakers are not connected
Connect the speaker with the correct
instrument position.
correctly.
@ 0 polarities. (See page 8.)
Severe hum or noise is heard.
The connecting cords are not of
Use shielded type cords.
shielded type.
A transformer, motor, TV or
Place the connecting cords ina
fluorescent light affects the
location away from a transformer or
connecting cord.
motor, and at least 3 meters (10 feet)
from a TV set or a fluorescent light.
If both are used at the same time,
separate the TV from the audio
components.
The receiver is not grounded.
Connect the ground wire to the
antenna ground terminal.
The connections are loose.
Make secure connections.
The plugs and jacks are dirty.
Wipe the plugs and jacks with a cloth
lightly dampened with alcohol.
The audio components are too close
toa TV set.
26
Advertisement
