Table of Contents
Advertisement
6. PRODUCT NOTICES
A. INSTALLER HAZARD NOTIFICATION
DANGER: Risk of fire, electric shock, or injury
to persons. Read important safety instructions on
inside front cover of these instructions.
WARNING: Risk of electrical shock. A licensed
electrician should make all electrical connections.
WARNING: Risk of electrical shock. Connect
only to a circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI).
WARNING: Risk of electrical shock. Disconnect
power before servicing.
WARNING: Risk of injury or property damage.
Please read all instructions thoroughly before
beginning installation, including the following
Product Requirements.
NOTICE: Follow all local plumbing and electrical
codes.
7. PRODUCT REQUIREMENTS
A. SUMMARY OF KEY REQUIREMENTS
S Install unit to a level subfloor.
S Provide properly dimensioned framing.
S Whirlpools are designed for a variety of installa-
tions, depending upon the model chosen.
S The optional apron must be installed before the
finish floor and wall materials are installed.
C. PRODUCT INSPECTION
Carefully unpack and inspect the whirlpool for damage.
Leave all materials in the carton during construction to
prevent damage.
NOTICE: Make sure both union connections to the
pump are securely tightened.
E. ELECTRICAL REQUIREMENTS
The installation must have a Class A Ground-Fault
Circuit-Interrupter (GFCI). The GFCI protects against
line-to-ground shock hazard. Use a 120 V, 15 A, 60 Hz
dedicated service for the whirlpool.
Kohler Co., Kohler WI
B. FACTORY-ASSEMBLED FEATURES
Factory installed components include pump with integral
timer and air switch transmitter. No installation is
needed.
The whirlpool pump and piping are factory-assembled.
WARNING: Unauthorized modification may
cause unsafe operation and poor performance
of the whirlpool. Do not relocate the whirlpool
pump, or make other modifications to the whirlpool
system, as this could adversely affect the
performance and safe operation of the whirlpool.
Kohler Co. shall not be liable under its warranty or
otherwise for personal injury or damage caused by
any such unauthorized modification.
B. PLUMBING SPECIFICATIONS
Confirm adequate support for the faucet; large faucets
that may be inadvertently used as a means of support
are not appropriate or safe for this installation.
D. CONNECTIONS AND SERVICE ACCESS
Before installation, ensure proper access to the final
connections.
NOTICE: Provide unrestricted service access to the
pump. An access panel must be constructed to allow for
sufficient clearance for servicing the pump or controls.
The access panel must be located at the pump end of the
whirlpool.
An optional removable apron is available for access to
the pump and controls. Additional access, however, may
make servicing of the pump and controls easier.
9
EA
113867-2-
(-)
Advertisement
Table of Contents
