Zenith Z-171 Series Service Manual page 55

LCD Driver Assembly Board
Page
4-11
Disassembly/Reassembly
To access the assembly, remove the back cover, the main logic board,
the disk drives, and the power control board. Refer to Figure 4-9 for
the following procedures.
1.
Remove the 6 screws at A that secure the support panel to the
frame.
2. Carefully lift the panel straight up while feeding the wires through
the appropriate holes.
3. Remove the 6 screws at B that secure the display.
4. Lift the unit from the front cover.
NOTE: The LCD is sensitive to direct heat and intense sunlight. Use ex-
treme care during handling or storage.
NOTE: When reassembling the support panel make sure that all necessary
wires and cables are routed through the appropriate holes.
Reverse the previous steps for reassembly.