Table of Contents
Advertisement
Mounting the WS-AI-DS06260 Antenna on a Ceiling
To install the WS-AI-DS06260 on a ceiling, refer to
1.
Rotate radome until tabs at the bottom of the radome line up with slots on the back plate. Pull
back the radome gently from antenna assembly.
2.
Identify the location for the connector access hole. Ensure a minimum 35 mm OD hole is
drilled on the surface (see
3.
Place the antenna on the ceiling tile.
4.
Following the guiding holes found on the metal backplate of the antenna, use the included
tapping screws to install antenna to the mounting surface. Recommended assembly torque is
3.0 N.M.
5.
Rotate the radome into place.
Figure 3-9
WS-AI-DS06260 Antenna Mounting Alignment
Figure 3-9
Figure
3-9).
Enterasys Wireless External Antenna Site Preparation and Installation Guide 3-13
Mounting the Antenna
and proceed as follows:
Advertisement
Table of Contents
