Table of Contents
Advertisement
2.
Secure the low-loss cable to the mast such that the cable connectors do not support the full
weight of the cable.
3.
Provide a drip-loop at the bottom of the low-loss cable just before it enters the building.
4.
Connect the opposite end of the low-loss cable to the lightning protector.
Caution: To avoid damage to the antenna cable and connectors, do not use tools to tighten cable
connectors.
Precaución: para evitar daños en los cables y el conector de la antena, no use herramientas para
apretar los conectores.
Achtung: Verwenden Sie kein Werkzeug zum Anziehen der Kabelanschlüsse. Durch Werkzeug
können das Kabel und die Anschlüsse beschädigt werden.
5.
Prior to securing the cable along its complete length, refer to
Point Antenna
Placement" on page 3-64. If required, adjust the direction of the antenna.
6.
Once the installation has been fully tested, tighten the antenna mounting nuts to lock the
antenna into its position.
Caution: To prevent damage, avoid over-tightening the connectors, nuts, and screws used to
mount the antenna.
Precaución: evite apretar demasiado los conectores, tuercas y tornillos usados para instalar la
antena, para no dañarlos.
Achtung: Beugen Sie Schaden vor, indem Sie die Anschlüsse, Muttern und Schrauben für die
Antenne nicht zu fest anziehen.
7.
Secure the cable along its complete length. No part of the cable should be allowed to hang free.
8.
Use waterproof stretch tape to seal all outdoor connectors.
Enterasys Wireless External Antenna Site Preparation and Installation Guide 3-63
Connecting Antenna Cables
"Optimizing Outdoor Point-to-
Advertisement
Table of Contents
