BMW X1 Owner's Manual page 94

CONTROLS
Before mounting
Before mounting child restraint systems, ensure
that the rear seat backrests are locked.
Move the rear seats into the rearmost position to
facilitate assembly of the child restraint system.
On the front passenger seat
Deactivating airbags
Warning
Active front-seat passenger airbags can injure a
child in a child restraint system when the air‐
bags are activated. There is a risk of injury.
Make sure that the front-seat passenger air‐
bags are deactivated and that the PASSEN‐
GER AIRBAG OFF indicator light lights up.
Before installing a child restraint system in the
front passenger seat, make sure that the front,
knee and side airbags on the front passenger
side are deactivated.
Deactivate the front-seat passenger airbags au‐
tomatically, refer to page 142.
Seat position and height
Before installing a child restraint system, move
the front passenger seat as far back as possible
and bring it as far up as possible to obtain the
best possible position for the belt and to offer
optimal protection in the event of an accident.
If the upper anchorage of the safety belt is lo‐
cated in front of the belt guide of the child seat,
move the front passenger seat carefully forward
until the best possible belt guide position is
reached.
Backrest width
Adjustable backrest width: before installing a
child restraint system in the front passenger seat,
open the backrest width completely. Do not
change the backrest width again and do not call
up a memory position.
94
Transporting children safely
Online Edition for Part no. 01402631131 - X/19
Child seat security
The rear safety belts and the front passenger
safety belt can be permanently locked to fasten
child restraint systems.
Locking the safety belt
1. Pull out the belt strap completely.
2. Secure the child restraint system with the
safety belt.
3. Allow the belt strap to be pulled in and pull it
tight against the child restraint system. The
safety belt is locked.
Unlocking the safety belt
1. Unbuckle the safety belt buckle.
2. Remove the child restraint system.
3. Allow the belt strap to be pulled in com‐
pletely.
In some cases it may be necessary to separate
the lower belt attachment. Safety belts, refer to
page 85.
LATCH child restraint fixing
system
General information
LATCH: Lower Anchors and Tether for Children.
Pay attention to the operating and safety infor‐
mation from the child restraint system manufac‐
turer when installing and using LATCH child re‐
straint fixing systems.