BMW X1 Owner's Manual page 205

▷ AT&T online registration link (https://
securec45.securewebsession.com/attsignal‐
booster.com/).
▷ U.S.Cellular online registration link (http://
www.uscellular.com/uscellular/support/fcc-
booster-registration.jsp).
Before use you must register your booster de‐
vice with your wireless provider.
If you should be requested by the FCC to cease
operating your booster you are not allowed to in‐
sert your mobile phone in the charging tray any‐
more unless the booster is permanently deacti‐
vated by your local BMW dealer.
You must not remove the booster from the car
nor use it with any other than the preinstalled
coupling device or antenna. Any modification of
the existing antenna or coupling device as well as
the use of other antennas or coupling devices
will cause the cease of the booster´s operating li‐
cense.
The booster device fulfills the network protection
standards as required by the FCC, such as inter‐
modulation limits, oscillation detection and gain
limits.
Booster Manufacturer: Kathrein Automotive
Model Number: LTECOMPB0
Part Number: 6803145-01
FCC-ID: 2ACC7LTECOMPB0
Cargo area
Cargo cover
Safety information
Warning
Loose objects or devices with a cable connec‐
tion to the vehicle, for instance mobile phones,
can be thrown about the car's interior while
driving, for instance in the event of an accident,
braking or evasive maneuver. There is a risk of
injury. Secure loose objects or devices with a
Online Edition for Part no. 01402631131 - X/19
Interior equipment
cable connection to the vehicle in the car's in‐
terior.
General information
The cargo cover is in two parts. This can be re‐
moved to load bulky luggage.
Removing
Rear cover
1. Detach the retaining straps at the tailgate.
2. Pry cover up a bit, arrow 1, and pull out of the
brackets toward the back, arrow 2.
Front cover
1. Push cover out of the bracket upward on
both sides, arrow 1.
2. Pull cover out of the bracket toward the rear
on both sides, arrow 2.
Installing
Proceed in the reverse order to reinstall. The
cargo covers must snap audibly into place on
their respective holders.
CONTROLS
205