BMW X1 Owner's Manual page 175

▷ If selector lever position N is set.
▷ Dynamic Traction Control DTC is activated or
DSC Dynamic Stability Control is deactivated.
▷ If DSC Dynamic Stability Control intervenes.
Setting the speed
Maintaining/storing the speed
Press the rocker switch up or down once while
the system is interrupted.
When the system is switched on, the current
speed is maintained and stored as the desired
speed.
The stored speed is displayed in the speedome‐
ter and in the instrument cluster, refer to
page 176.
DSC Dynamic Stability Control is switched on, if
necessary.
The speed can also be stored by pressing a but‐
ton.
Press the button.
Online Edition for Part no. 01402631131 - X/19
Driving comfort
Changing the speed
Press the rocker switch up or down repeatedly
until the desired speed is set.
If active, the displayed speed is stored and the
vehicle reaches the stored speed when the road
is clear.
▷ Each time the rocker switch is pressed to the
point of resistance, the desired speed in‐
creases or decreases by approx.
1 mph/1 km/h.
▷ Each time the rocker switch is pressed past
the point of resistance, the desired speed in‐
creases or decreases by a maximum of
5 mph/10 km/h.
▷ Pressing the rocker switch to the resistance
point and holding it accelerates or deceler‐
ates the vehicle without requiring pressure on
the accelerator pedal.
After the rocker switch is released, the vehi‐
cle maintains its final speed. Pressing the
switch beyond the resistance point causes
the vehicle to accelerate more rapidly.
Continuing cruise control
General information
An interrupted cruise control can be continued
by calling up the stored speed.
Make sure that the difference between current
speed and stored speed is not too large before
calling up the stored speed. Otherwise, uninten‐
tional braking or accelerating may occur.
In the following cases, the stored speed value is
deleted and cannot be called up again:
CONTROLS
175