Step 2: Position The Oven - TurboChef HHC-3240 Installation Manual

4 INSTALLATION
DANGER: DO NOT place any body parts underneath the oven while it is being
lifted. The oven weighs approximately 800 lbs. (363 kg); whenever the oven is
lifted, a crush hazard is present.
Remove the pallet from underneath the oven.
1.6
underneath the oven while it is lifted. Remove the pallet by holding onto the edge
and pulling it away from the oven.
Lower the oven to the ground and let it sit on the attached maneuvering casters.
1.7
Disconnect the lifting pole from the lifting adapters and remove the lifting pole.
1.8

STEP 2: POSITION THE OVEN

Maneuver the oven to its fi nal location.
2.1
Attach the legs. Each leg must be attached with four of the supplied bolts (refer to
2.2
page 2) and with the curved portion facing outward. Ensure all bolts are
tightened.
Re-insert the lifting pole through the lifting brackets.
2.3
Re-position the lifts and re-attach the lifting adapters to the lifting pole.
2.4
WARNING: Insert safety pins through the lifting pole or place pipe caps on the
ends (whichever
DANGER: The oven is top heavy and will tip. Position someone to steady the
oven during lifting as shown in STEP 1.5, page 3 to minimize the risk of tipping.
Using the lifts, slowly raise the oven. Keep the unit level.
2.5
DANGER: DO NOT place any body parts underneath the oven while it is being
lifted. The oven weighs in excess of 800 lbs. (363 kg); whenever the oven is lifted,
a crush hazard is present.
Rotate the oven to the orientation as shown adjacent.
2.6
Lower the oven to the ground.
2.7
Remove the maneuvering casters from the back of the
2.8
oven.
Immediately discard the maneuvering casters. These casters
2.9
are not designed to be used again.
Replace the maneuvering casters with the supplied bolts
2.10
(refer to page 2) and ensure that all the holes in the rear of
the oven are plugged.
applies).
DO NOT place any body parts
Step 2.8
Step 1.7
Step 2.2
Step 2.4
Step 2.6