Step 6: Install The Window (Select Models Only) - TurboChef HHC-3240 Installation Manual

8 INSTALLATION
Install the conveyor drive chain guard. The chain guard fi ts in place over the
5.12
chain and the end of the belt.
Attach one leveler to each of the four legs.
5.13
Lower each leveler until the base rests on the fl oor. Equal
5.14
pressure should be on both the caster and the leg, which
helps prevent the casters from being damaged over time.
Ensure the casters are locked.
5.15
Attach the cooling duct(s) and secure it in place with the supplied thumb screw
5.16
(refer to page 2).

STEP 6: INSTALL THE WINDOW (SELECT MODELS ONLY)

Remove the right hand window bracket.
6.1
Insert the left side of the window into the left hand bracket.
6.2
Insert the right side of the window into the previously removed right hand bracket.
6.3
Install the supplied screw (refer to page 2) in the top hole of the bracket and
6.4
securely tighten.
Install the supplied screw (refer to page 2) in the bottom hole of the bracket and
6.5
securely tighten.
Close the window. When closed, the window should appear as shown in STEP 6.5.
6.6
NOTE: Repeat STEP 6 for the middle and top ovens if double or triple-stacking ovens.
Chain Guard
Step 5.12
Step 5.13-5.14
Step 5.16
Step 6.2-6.3
Step 6.4-6.5
Step 6.6