Assembly Instructions; Step 1: Remove The Oven From The Pallet - TurboChef HHC-3240 Installation Manual

Assembly Instructions

The following instructions detail how to assemble the HhC 3240 oven. The oven weighs approximately 800
lbs. (363 kg). DO NOT attempt to assemble this oven with damaged or defective lifts, legs, or casters. Call
800.90 (+1 214-379-6000) for specifi cations, pricing, and availability on lifts and lifting adapters.
TURBO

STEP 1: REMOVE THE OVEN FROM THE PALLET

Remove the oven accessories and materials from the pallet. Store all
1.1
accessories and materials in a safe, accessible place; they will be used later in the
assembly proccess.
Remove all packaging that attaches the oven to the pallet.
1.2
Insert the lifting pole through the lifting brackets. The lifting pole must be to the
1.3
following specifi cations:
schedule 40 steel.
Two lifts are required to lift the oven. Position the lifts
1.4
at each end of the oven and connect the lifting pole to
the lifts using the lifting adapters.
WARNING: Insert safety pins through the lifting pole (as
shown in the adjacent fi gure) or place pipe caps on the
ends (whichever applies).
WARNING: The oven is top heavy and will tip. Position someone to steady the
oven during lifting as shown in
Using the lifts, slowly raise the oven above the pallet. Keep the unit level.
1.5
10 feet (3.05 m) long, 1.5 inch (38.1 mm) diameter,
1.5 to minimize the risk of tipping.
STEP
Step 1.1
Step 1.2
Step 1.3
Step 1.4
Steady the
Oven
Step 1.5
3
Lifting Adapter
Safety Pin