IBM N3240 Installation And Setup Instructions page 11

FRONT
Left and Right
H1
H2
H3
H4
Chassis attach screws
H5
Top rail screws
H6
H7
H8
H9
Bottom rail screws
H10
Chassis attach screws
H11
H12
Figure 5. Rail positioning guide
Note: When installed, each N3240 unit will occupy a 4U space.
Using two silver pan head M5 screws, attach the rail to the front of the rack using holes H6 and H10.
Tighten these screws with a screwdriver.
3. At the rear of the rack, position the rail at the same EIA location used in step 2 (make sure that the
locating pins seat properly). Using two silver pan head M5 screws, attach the rail to the rack using
holes H5 and H11. Tighten these screws with a screwdriver.
4. Tighten the four rail adjustment screws on the installed rail.
5. Using a Phillips screwdriver, install a rear tie-down plate on the rail using two M5 Phillips flat-head
screws 1 , as shown in Figure 6 on page 4.
Section of rack EIA rail
Rails
Locating pins
Locating pins
REAR
Left and Right
Rails
H1
H2 1 EIA unit (1U)
H3
H4
Top rail screws
H5
H6
H7
H8
H9
H10
H11
Bottom rail screws
H12
exn300016
Installation and setup instructions
3