IBM N3240 Installation And Setup Instructions page 17

Figure 14. Cabling the networking, management, and 10 GbE ports in a 10/100/1000 setup in switchless Clustered
Data ONTAP
4. Perform one of the following steps depending on your configuration:
v For 10/100/1000 setup in 7-Mode: Connect the management port from the system to the network,
using an Ethernet cable (Figure 15).
!
LNK
LNK
0b 0a
Figure 15. Cabling the management port from the system to the network in 7-Mode
v For 10 GbE setup in 7-Mode: Connect the management port ( 2 in Figure 13 on page 8) from the
system to the management switch ( 4 in Figure 13 on page 8).
v For 10/100/1000 setup in switchless Clustered Data ONTAP: Connect the management port ( 1 in
Figure 14) to the management network switch.
Important: The network for the management port must negotiate down to 10/100 or auto-negotiate.
5. Perform the following step if you have a 10/100/1000 setup in switchless Clustered Data ONTAP:
v Connect port e1a in the first controller to port e1a in the second controller, and connect port e1b in
the first controller to port e1b in the second controller ( 3 in Figure 14).
3
1
+
-
e1a e1b
ACT ACT
LNK LNK
2
e0a e0c
e0b
e0d
Installation and setup instructions
9