Connections And Operations For Viewing; The Picture Played Back On Your Tv - Pentax MOVIE 8 PV-C800A Instruction Manual

8mm video camera/recorder
Table of Contents

Advertisement

CONNECTIONS AND OPERATIONS FOR VIEWING
THE
PICTURE PLAYED BACK ON YOUR
TV
To play back a tape recorded on your Video Cameral Recorder and view it on your TV receiver, you must connect the
Video Camera/Recorder to the TV receiver using RF Converter Unit (Accessory
No.
2) or Audio
/
Video Output Cable
(Optional).
Example 1:
If
your TV is a regular TV, use
RF
Converter Unit (Accessory No.2)
UHF Antenna
VHF
Antenna
~
Cameral Recorder
r-~~ '---T_V_H~F~I=N=r~ ~~~==~========n
~
.".Ohm _ohm
c
DO[
Antenna
Adaptor
(75-ohm to 300-ohm)
(Accessory
No.
11)
75-ohm Coaxial Cable
(Accessory No.3)
Antenna Adaptor
(300-ohm to 75-ohm)
(Accessory No.4)
To "IN FROM
ANT"
To "OUT TO TV"
RF Converter Unit (Accessory No.2)
1. Disconnect the VHF antenna leads from the rear of
the TV receiver.
NOTE: Leave the UHF antenna leads connected to
the TV.
2. Connect the VHF antenna lead to "IN FROM
ANT" on the RF Converter Unit.
If the table is
round (75-ohm), it will connect directly to the "IN
FROM ANT"
.
If it is the flat type (300-ohm), con-
nect it to the Antenna Adaptor (300-ohm to
75-ohm) and slip the Adaptor on to the "VHF IN
FROM ANT" terminal.
3. Connect the 75-ohm Coaxial Cable to "OUT TO
21
TV" on the RF Converter Unit.
4. Connect the other end to the VHF antenna terminal
on the TV, as illustrated above.
If the VHF antenna terminal on the TV is the flat
type (300-ohm), connect the end of coaxial cable to
the Antenna Adaptor (75-ohm to 300-ohm, Ac-
cessory No. 11) and connect the AdaptoJ to the
VHF antenna terminal on the TV.
5. Connect the Connector Cable from RF Converter
Unit to "A/V" jack on the Video Camera
l
Recorder.
6. Turn on the TV and set to Channel3 unless Channel
3 is one of the TV stations used in your area. If
Channel
~
is used in your area, set your TV to Chan-
nel4.

Advertisement

Table of Contents
loading

Table of Contents