Kenwood TM-251A Instruction Manual page 89

RECEIVING
1 Tune to the prearranged frequency.
2 Press [DTSS] (1 s).
e "PAG" appears.
You are ready to receive a call addressed with your
Station code or a Group code. If no signal is received
for more than 2 seconds after a Page has opened the
squelch, the squelch then closes.
m Receiving a Call with your Station Code
When a signal is received encoded with your Station
code, the squelch opens and you hear an alert tone
from the speaker. In addition, the Display shows "PO"
and the calling station's code.
Press [PTT] while "P" is blinking to respond to the
calling party.
82
m Receiving a Call with a Group Code
When a signal is received encoded with the correct
Group code, the squelch opens and you hear an alert
tone from the speaker. In addition, the Display shows
the received Group code and in which memory
(1 to 9) that Group code has been stored.
iNgSG
Press [PTT] while "P" is blinking to respond to the
calling party.
Note:
> "Err" appears on the Display if your transceiver fails to
receive the Page code correctly.
> The microphone is inhibited while the Page code is
transmitted.
> if Page and Tone Alert are ON, there is no speaker output
except the alarm tone even if a signal is received with the
correct Page code.