Kenwood TM-251A Instruction Manual page 2

Notice to the user:
Gne or more of the following statements may be
applicable to this equipment.
FCC WARNING
This equipment generates or uses radio frequency energy.
Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in
the instruction manual. The user could lose the authority to
operate this equipment if an unauthorized change or
modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE
FCC
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can generate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the
-interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
*® Reorient or relocate the receiving antenna.
@ increase the separation between the equipment and receiver.
® Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer for technical assistance.
Models Covered by this Manual
TM-251A: 144 MHz FM transceiver
(U.S.A./ Canada/ General)
TM-251E: 144 MHz FM transceiver
(Europe)
TM-451A: 440 MHz FM transceiver
(U.S.A./ Canada)
430 MHz FM transceiver
(General)
TM-451E: 430 MHz FM transceiver
(Europe)
Note:
> The TM-251 series is used for all illustrations and all LCD
example displays.
> Functions requiring the microphone keypad, such as Remote
Control, cannot be used without a keypad-equipped microphone.
This type of microphone is optional for some transceiver
versions.