Kenwood TM-251A Instruction Manual page 87

3 Turn the Tuning control, or press microphone
[UP]/[DWN], to select Page memory A.
e Alternatively, if your microphone is equipped with a
DTMF keypad, the Page memory can be entered by
using the keypad numeric keys including [A]. After
entering the Page memory, the Page code stored in
that memory appears. "---" appears when no
code is stored. Jump to Step 5 below.
4 Press [DTSS].
e Pressing [DTSS] shifts the transceiver between
Page code entry and Page code memory number
modes.
« The large Page code "P" and "PAG" start blinking.
5 Select a 3-digit number (000 to 999) for your Station
code by turning the Tuning control or by pressing
microphone [UP]/[DWN].
Alternatively, if your microphone is equipped with a
DTMF keypad, the Page code also can be entered
by using the keypad numeric keys. Press the 3
numeric keys in sequence for the code you want.
Jump to step 7 below.
13 8 7 2 over
80
Press [DTSS].
Press [DTSS].
« The keypad can be used as in Step 5.
You can use the Group code or Station code
immediately that was stored or selected last.