Table of Contents
Advertisement
–
Manually press the brake caliper to the brake disc to push
back the brake piston. Ensure that brake fluid does not flow
out of the brake fluid reservoir, extracting it by suction if it
does.
Info
Make sure when pushing back the brake piston that you
do not press the brake caliper against the spokes.
–
Remove the cotter pins
F00155-10
brake linings.
–
Clean the brake caliper and brake caliper support.
–
Check that leaf spring
6
plate
in the brake caliper support are seated correctly.
Info
The arrow on the leaf spring points in the rotation
direction of the brake disc.
S01251-10
–
Insert the new brake linings, insert pin
3
cotter pins
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
H00025-10
point.
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
O-ring.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
F01546-10
3
4
, pull out pin
5
in the brake caliper and sliding
4
, and mount the
.
7
A
.
p. 138)
1
with membrane
BRAKE SYSTEM 12
, and remove the
is mounted on the
2
and the
93
Advertisement
Table of Contents
