Electrical System 14; Removing The 12-V Battery; Installing The 12-V Battery - KTM 350 SX-F 2020 Owner's Manual

Table of Contents

Advertisement

14.1

Removing the 12-V battery

Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
Allow the voltage regulator to cool down before performing any work.
Note
Environmental hazard 12 V batteries contain environmentally hazardous materials.
Do not dispose of 12 V batteries as household waste.
Dispose of 12 V batteries at a collection point for used batteries.
14.2

Installing the 12-V battery

Preparatory work
Press and hold the kill switch
the engine stops.
Remove the seat. (
Main work
Hang the voltage regulator to the side.
Disconnect negative cable
Pull back positive terminal cover
tive cable from the 12-V battery.
Remove screw
Pull holding bracket
upwards.
F00138-10
Main work
Insert the 12 V battery into the battery compartment with the
terminals facing forward and secure with holding bracket
12-V battery (HJTZ5S-FP-C) (
Mount and tighten screw
Guideline
Remaining screws,
chassis
Connect positive cable
Guideline
Screw, battery termi-
nal
Connect negative cable
Guideline
Screw, battery termi-
nal
H00386-10
Contact disks
cable sockets
nal.
Slide positive terminal cover
Position the voltage regulator.

ELECTRICAL SYSTEM 14

while the engine is idling until
p. 62)
1
from the 12-V battery.
2
and disconnect the posi-
3
.
4
forward and remove the 12-V battery
p. 131)
2
.
M6
10 Nm (7.4 lbf ft)
3
to the 12-V battery.
M5
2.5 Nm
(1.84 lbf ft)
4
to the 12-V battery.
M5
2.5 Nm
(1.84 lbf ft)
A
must be mounted under screws
6
with the claws toward the battery termi-
7
over the positive terminal.
1
.
5
and
99

Advertisement

Table of Contents
loading

Table of Contents