14 Electrical System; Removing The 12-V Battery; Installing The 12-V Battery - KTM 350 SX-F 2021 Owner's Manual

14 ELECTRICAL SYSTEM

14.1
14.2
108

Removing the 12-V battery

Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
Note
Environmental hazard 12 V batteries contain environmentally hazardous materials.
–
Do not dispose of 12 V batteries as household waste.
–
Dispose of 12 V batteries at a collection point for used batteries.
F00138-10

Installing the 12-V battery

H00386-10
Preparatory work
–
Remove the seat. ( p. 67)
Main work
–
Hang the voltage regulator to the side.
–
Disconnect negative cable
–
Pull back positive terminal cover
tive cable from the 12-V battery.
–
3
Remove screw .
–
4
Pull holding bracket forward and remove the 12-V battery
upwards.
Main work
–
Insert the 12 V battery into the battery compartment with the
terminals facing forward and secure with holding bracket
12-V battery (HJTZ5S-FP-C) (
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
3
Connect positive cable
Guideline
Screw, battery termi-
nal
–
4
Connect negative cable
Guideline
Screw, battery termi-
nal
A
Contact disks must be mounted under screws
6
cable sockets with the claws toward the battery termi-
nal.
–
Slide positive terminal cover
–
Position the voltage regulator.
1
from the 12-V battery.
2
and disconnect the posi-
p. 140)
2
.
M6 10 Nm (7.4 lbf ft)
to the 12-V battery.
M5 2.5 Nm
(1.84 lbf ft)
to the 12-V battery.
M5 2.5 Nm
(1.84 lbf ft)
5
7
over the positive terminal.
1
.
and