Table of Contents
Advertisement
Shows one of the
options below:
Cal Set A
Active Cal Set
Cal Set B
Cal Set C
Best Fit
Cal Set A
Cal Set B
Select Cal Set
Cal Set C
Best Fit
DAC Zero Trim
Note: Loop must be
DAC Zero Trim
removed from
Automatic Control
DAC Span Trim
Note: Loop must be
DAC Span Trim
removed from
Automatic Control
Loop Test
Loop Test
Note: Loop must be
12.000
removed from
Automatic Control
LRV
#. ##
URV
#. ##
Damping
#. ##
Enabled
NAMUR
Disabled
Fast SOR
Filter Perf
Standard SOR
ST 800 Pressure Transmitter User's Manual
78
Displays the current calibration used
by the sensor.
Cal Set B is only available with dual
calibration
Cal Set C is only available with triple
calibration
This selection allows the user to
choose calibration type from the list.
Cal Set B is only available with dual
calibration
Cal Set C is only available with triple
calibration
This selection allows the loop zero
output 4mA value to be trimmed.
Note: You must connect a current
meter to the transmitter to monitor the
loop output.
This selection allows the loop
span output 20mA value to be
trimmed.
Note: You must connect a current
meter to the transmitter to monitor the
loop output.
This selection allows the user to force
the DAC output to any value between
3.8 and 20.8 mA.
Note: This selection will put the
DAC into Fixed Output Mode, as
indicated by the flashing output
value. Navigation away from this
menu item will return the loop to
Normal (Automatic) Mode.
The limits are:
2X the Lower Range Limit (LRL) of
the Meter Body and 2X the Upper
Range Limit (URL) of the Meter
Body
Selection applies digital filtering to
suppress noise effects on the PV.
The limits for this value are 0.0 to
32.0 seconds
Disabling sets the loop output and
burnout levels to the Honeywell levels
Fast Speed of Response Standard
Speed of Response
Read Only
Parameter
Press to enter
menu selection
and to select
from list
to enter
Press to enter
menu selection
and to select
number.
to enter and
shift to the next
digit to the right
Press to enter
menu selection
and to select
number.
to enter and
shift to the next
digit to the right
Press to enter
menu selection
and to select
from list
to enter
Revision 15
Advertisement
Table of Contents
