Operating the HomeLink
Press the appropriate HomeLink
light on the HomeLink
The HomeLink
the button is pressed.
Erasing the entire HomeLink
Before programming
■
Install a new battery in the transmitter.
●
The battery side of the transmitter must be pointed away from the HomeLink
●
Certification for the garage door opener
■
This device complies with Part 15 of the FCC Rules and with RSS-210 of the IC
Rules.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
WARNING: This transmitter has been tested and complies with FCC and IC rules.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user' s authority to operate the device.
transceiver should turn on.
continues to send a signal for up to 20 seconds as long as
memory (all three programs)
3-7. Other interior features
button. The HomeLink
Press and hold the 2 outside but-
tons for 20 seconds until the indi-
cator light flashes.
If you sell your vehicle, be sure to
erase the programs stored in the
HomeLink
indicator
memory.
3
.
381