3-1. Using the touch screen
The initial screen
To avoid damaging the touch screen
■
Touch the screen lightly with your finger. If there is no response, remove your fin-
●
ger from the screen and try again.
Remove any dirt on the screen by wiping with a soft cloth. Do not use detergent.
●
When using the touch screen
■
If the screen is cold, the display may be dark, or the system may seem to be
●
operating slightly slower than normal.
The screen may seem dark and hard to see when viewed through sunglasses.
●
Change your angle of viewing, adjust the display on the "Display" screen or
remove your sunglasses.
226
If the "POWER" switch is set to
ACCESSORY or ON mode, the
initializing screen will be displayed
for a few seconds as the system
starts up.