Epson SC-P5300 Series User Manual page 107

SC-P5300 Series User's Guide
Setting item Set value
Poster Board
Remove
Print Adjustments
Paper Feed Adjust
Print Head Alignment
Advanced Paper Settings
Paper Thick- 0.01 to 1.50 mm
ness
0.4 to 59.1 mil
Paper Suction
-4 to 4 (0
Drying Time Drying Time per Pass,
Drying Time per Page
Paper Size
On
Check
Paper Feed Off- -0.70 to +0.70 %
set
Paper Feed Off- -0.70 to +0.70 %
set(Bottom)
Restore Default Settings
Menu List
*
)
*
, Off
Explanation
Poster board is ejected.
Select the following when banding (horizontal banding, tint
unevenness, or stripes) is detected in printing results.
"Paper Feed Adjust" on page 48
U
This menu is used when graininess is detected in printing results.
"Print Head Alignment" on page 49
U
This item is only displayed for Custom Paper settings.
Thickness of poster board that can be used on the printer is 0.8 to
1.50 mm (3.15 to 59.1 mil)
Can be adjusted in 0.01 mm (0.1 mil) increments.
Thin or soft paper may not be fed correctly. If this occurs, reduce
the setting value.
You can set the drying time for each print head movement (pass) or
the drying time for each page.
Try setting it to Off if a paper width error is displayed even though
the paper is correctly loaded. However, we recommend that this
ordinarily be set to On. The changed settings are applied when you
reload the paper.
This is displayed when Custom Paper is selected in Paper Type.
If banding (horizontal banding) or uneven colors occur, use this
function to do adjustments.
For example, when printing at a data size of 100 mm and a print
size of 101 mm, the offset is 1.0 %. Therefore, you would enter a
value of -1.0 %.
This is displayed when Custom Paper is selected in Paper Type.
If banding (horizontal banding) or uneven colors occur on the
bottom edge (15 mm) of the paper, use this function to do
adjustments.
This is displayed when a Paper Type other than Custom Paper is
selected.
Restores all the setting conditions in Advanced Paper Settings to
their default settings.
107