Esc F T1 T2 - Epson TM-U925 Manual

ESC f t1 t2

[Name] Set slip paper waiting time
[Format] ASCII
Hex
Decimal
0 £ t1 £ 15
[Range]
0 £ t2 £ 64
[Description] Sets the time that the printer waits for slip paper to be inserted and the time from insertion
of the slip to the start of printing.
· t1 specifies the wait time for slip paper to be inserted.
· t2 specifies the time from insertion of the slip to the start of printing.
· This command sets the slip paper wait time to [ t1 ´ 1] minutes. If slip paper is not
inserted within this time, the printer cancels slip paper mode and selects the default
paper type for ESC c 0.
· When t1 is set to 0, the printer waits until slip paper is inserted.
· The printer starts operation [ t2 ´ 0.1] seconds after detecting a slip.
· When either t1 or t2 is out of the specified range, this command is ignored and the
[Notes]
previously set value is not changed.
· Using DLE ENQ 3 cancels the slip waiting state. The data in the receive buffer and
the print buffer are cleared in this time.
· For the following notes, assume that ESC c 4 is set to stop printing when the absence
of slip paper is detected:
· If the printer is in a paper-end and enters the slip waiting state by feeding a slip with
the SLIP FEED button, there is no limit on the slip waiting time if the printer is not at the
beginning of a line.
· If the printer is in a paper-end and enters the slip waiting state by attempting to print
double-height characters on the last line of the slip, there is no limit on the slip waiting
time.
· When the slip waiting time is set using this command and when printing stops because
paper-end is enabled by using ESC c 4 n , it is desirable to print on the remaining slip
paper while checking the slip status by using GS r 3.
[Default] t1 = 0, t2 = 10
EPSON
ESC f t1
1B 66 t1
27 102 t1
TITLE
TM-U925
Specification
(STANDARD)
t2
t2
t2
SHEET
REVISION
A
NO.
NEXT SHEET
91 90