Reading Micr Characters And Printing Endorsements - Epson TM-U925 Manual

3.14 Reading MICR Characters and Printing Endorsements

(when the printer is used with the MICR reader)
Use the following procedure to read MICR characters:
User Operation
1
Transmit FS a 0 <00>H.
(Transmit DLE ENQ 3.)
2 Insert a check.
3 (Transmit FS a 0 <00>H.)
4
Transmit FS a 1.
5 Transmit endorsement
printing data.
6
Transmit FF.
7 Eject the check paper.
NOTES: 1. A personal check is ejected in the forward direction only.
2. The paper roll must be loaded onto both the receipt and journal sides correctly before
selecting MICR function by transmitting FS a 0. Otherwise, check paper is not fed
properly.
3. The check waiting state is canceled using DLE ENQ 3.
4. After the personal check is ejected, the SLIP LED lights and the printer does not proceed
to the next operation until the check is removed.
5. A personal check should be inserted by matching the top edge with the form stopper and
the right side with the right side of the paper insert portion.
6. The check waiting time and the interval from when a check is inserted to when the
operation starts can be set using ESC f.
7. To check the MICR function status exactly, DLE EOT BS 1. (Refer to APPENDIX H,
Example Read Control for MICR Characters .)
8. Remove an ejected personal check by pulling it upward. Do not pull it out in the
horizontal direction.
EPSON
Printer Operation
Mechanically switches to MICR mode and waits for a personal
check to be loaded. The SLIP LED blinks.
(when the check waiting state is canceled)
Detects the check, lights the SLIP LED, and reads MICR
characters. After reading, transmits the reading results.
(Rereads the check and transmits the reading result.)
Loads the check paper to the print starting position.
Prints data and feeds paper.
After printing, ejects paper.
The SLIP LED blinks until the check is removed.
Switches to two sheet mode. The SLIP LED blinks.
TITLE
TM-U925
Specification
(STANDARD)
SHEET NO.
REVISION
NEXT
A
51
SHEET
50