Epson TM-U925 Manual page 46

2) DIP switch 2: 8 switches
SW2
1 Auto line feed
2 Receive buffer
3 Font selection (default)
Carriage speed
4
(default for paper roll printing)
5 Handshaking (BUSY condition)
6 Internal use
7 I/F pin 6 reset signal
8 I/F pin 25 reset signal
NOTES: 1 When pin 6 of the interface connector is used for the reset signal, the printer is reset at
MARK on the RS-232C level.
2 When pin 25 of the interface connector is used for the reset signal, the printer is reset at
SPACE on the RS-232C level or at HIGH on the TTL level.
3 Changes in DIP switch settings (excluding switches 2-1, 2-7, and 2-8 I/F reset signals) are
recognized only when the printer power is turned on or when the printer is reset by using
the interface. If the DIP switch setting is changed after the printer power is turned on,
the change does not take effect until the printer is turned on again or is reset.
4 If you turn on DIP switch 2-7 or 2-8 when the printer power is turned on, the printer may
be reset, depending on the signal state. DIP switches should not be changed while the
printer power is on.
EPSON
Table 3.3.3
Function
TITLE
TM-U925
Specification
(STANDARD)
DIP Switch 2
ON
Always enabled
32 bytes
9 ´ 9
Low
Receive buffer-full
Fixed
Enabled
Enabled
SHEET
REVISION
A
OFF
Always disabled
2048 bytes
7 ´ 9
High
Off-line or
receive buffer-full
--
Disabled
Disabled
NO.
NEXT SHEET
39 38