Canon EOS C300 Mark II Instruction Manual page 170

Configuring Connection Settings
[RTSP+RTP]: This setting uses the RTSP (real time streaming) protocol to control the streaming server
(camera) in real time and the RTP protocol for the broadcast over IP. With the RTSP protocol,
the receiver can control when to start and stop the broadcast.
* A decoder compatible with FEC error correction is required.
170
Function Settings: Browser Remote
This section continues the connection settings wizard (A 167). A user name and password are required to log
in to the Browser Remote application. In the function settings you will configure up to three different users for
single-user or two-user operation.
1 Select [Create New Func. Setting].
• Once you have added multiple function settings, you can select [Select Existing Setting] to reuse Browser
Remote settings that you saved previously.
2 Select the number of users.
3 Enter the user names and passwords as necessary.
• For a single user, select [Full: User Name] and [Full: Password] > [OK].
For two users, select [Camera: User Name], [Camera: Password], [Meta: User Name] and [Meta: Password]
> [OK].
• Enter the desired user name and password using the keyboard screen (A 36).
4 Select [OK]
• The function settings are saved to a [MODE] file.
5 Select the connection setting (SET1 to SET20) where to save the settings.
6 When the confirmation message appears, press SET.
• The camera will connect to the network and will be ready to accept commands from the Browser Remote
application (A 183).
Options for [User Setting]
[One User (Full)]:
A single user who can access all Browser Remote screens.
[Two Users (Camera/Meta)]:
You will set up two user names and passwords, one who can access the main Browser Remote
screen to control the camera ([Camera]) and one who can access the metadata screen to
update the user memo and GPS information ([Meta]).
NOTES
• The user names for the [Camera] and [Meta] users cannot be the same.
Function Settings: XC Protocol
Set a user name and password to connect to an XC Protocol compatible device connected to a network.
1 Select [Create New Func. Setting].
2 Set the authentication method used by the XC Protocol (HTTP) server.
• After selecting [Basic Authentication] or [Digest Authentication], set the user name and password.
User name: 5 to 15 alphanumeric characters or symbols.
Password: 8 to 32 alphanumeric characters or symbols (use at least 2 types from each).
• Enter the desired user name and password using the keyboard screen (A 36).
3 Select [OK].
• The function settings are saved to a [MODE] file.
4 Select the connection setting (SET1 to SET20) where to save the settings.