Look Files - Canon EOS C300 Mark II Instruction Manual

Custom Picture Settings

Look Files

You can register LUT files created with Blackmagic Design's DaVinci Resolve as Look Files in the custom picture
file. Using a Look File allows you to adjust the video quality of the recorded video. These adjustments apply also
to proxy clips, photos, and screen/output terminals.
132
1 Insert the SD card with the desired Look File (.cube format, located in the root directory of the SD
card) into the camera's SD card slot.
2 Select a custom picture file. (A 129)
3 Select
4 Select
• The Look Files in the SD card will be displayed.
5 Select the desired Look File.
6 Select the [Gamma/Color Space] setting to use after the Look File is applied.
7 Select [OK] twice.
• The selected Look File will be loaded and registered to the custom picture file.
• Then, the image quality adjustments set in the Look File will be applied, and
• When you disable the image quality adjustments set in the Look File, select
> [Edit / File] > [Look File] > [Off].
NOTES
About Look files
- The camera supports LUT files (3D LUT/.cube format) in 17 grid or 33 grid format created with Blackmagic
Design's DaVinci Resolve.
- LUT files with input ranges outside the 0 to 1 range in the header ("LUT_3D_INPUT_RANGE") are not
supported.
- LUT files which include values outside of the 0 to 1 range in the data area are not supported.
- LUT files 2 MB and larger, as well as files with a name containing over 65 characters are not supported.
- Only the following characters can be used in the file name:
Numbers 0 to 9, upper/lower case letters a to z, underscore (_), hyphen (-), period (.) and a single byte
space.
• Save a Look File to the root directory of the SD card.
• If the correct input/output gamma curve and color space conversion are not selected, video will not be output
correctly.
• A Look File cannot be used if the [Gamma/Color Space], [HLG Color] or [Over 100%] settings are changed
after registering it.
• When the gamma curve component of the [Gamma/Color Space] setting in the custom picture is set to either
[BT.709 Normal], [BT.709 Standard] or [BT.709 Wide DR], super-white (video signal above 100%) and super-
black (video signal below 0%) levels of brightness will be clipped. When the video signal contains super-white
brightness levels, select
[Press] and then activate the Look File to apply it to a signal compressed to 100%.
• When playing RAW clips, the Look File registered when the clip was recorded will only be applied to the
thumbnail and not the clip itself.
Deleting a Look File
You can delete Look Files registered in custom picture files.
1 Select a custom picture file (A 129).
/
> [ Custom Picture] > [Edit
/
> [ Custom Picture] > [Edit
> [/ Custom Picture] > [Edit / File] > [Other Functions] > [Over 100%] >
/
File] > [Gamma/Color Space] > Desired option.
/
File] > [Look File Setup] > [Register].
will appear on the screen.
> [/ Custom Picture]